Filter
Top Products
trouble-shooting
5. WOOD BINDS, SMOKES AND MOTOR SLOWS
DOWN OR STOPS WHEN RIPPING.
a. Dull blade or warped board.
Sharpen or replace the saw blade. Avoid the
attempted use of severly warped material.
b. Feed rate too fast.
Slow Feed Rate.
c. Saw blade heels.
Check and align as described in Alignment
Procedure Section, Step Five.
d. Fence not straight.
Replace fence.
e. Carriage Assembly Loose on Arm.
Refer to adjusting carriage bearings in adjustments
to compensate for wear section,
6. BOARD PULLS AWAY FROM FENCE WHEN
RIPPING.
a. Saw Blade has heel.
Corrective action is the same as preceding
instructions explained in paragraph c.
7. WORKPIECE STRIKES SPREADER WHEN RIPPING.
a. Adjust spreader per instructions in Step Six under
"'Alignment of Spreader for Ripping".
& SAW DOES NOT TRAVEL SMOOTHLY ON ARM
TRACKS.
a. Dirty tracks.
Clean Tracks.
b. Bad Bearing.
Replace Bearing.
c. Worn Tracks
Replace Tracks
9. CLAMPING FORCE NOT SUFFICIENT AT MITER
ANGLES OTHER THAN 45 ° .
a. Arm Control Lever requires Adjustment.
Refer to Arm Lock Adjusting Wheel in Adjustments
to Compensate for Wear Section.
10. CLAMPING FORCE NOT SUFFICIENT AT BEVEL
ANGLES OTHER THAN 45 ° .
a. Bevel Lock Lever Requires adjusting.
Refer to Adjusting Bevel Lock Lever in
Adjustments to Compensate for Wear Section.
IN RIP POSITION
TOp vIEW WITH ARM 90 ° TO THE FENCE
I ] ) Vq T_FkFALc EE
\Y
HEEL TO RIGHT: HEEL TO LEFT:
I NCORR ECT iNCORRECT
FEED
DIRECTION
FENCE
WlTi FENCE
CORRECT
11. DEPTH OF CUT VARIES FROM ONE END OF
WORK PIECE TO THE OTHER.
a. Table Top not parallel with Arm.
Refer to Attaching and Leveling table Mtg. Support
Channels in Step One Align. Section.
12. BLADE TENDS TO ADVANCE THRU LUMBER TOO
FAST.
a. Dull Blade.
Replace or sharpen blade.
b. Not advancing Saw Blade properly.
Draw Saw Blade across lumber with a slow and
steady pull.
32