Filter
Top Products
getting to know your drill press
To turn drill ON ..
Insert finger under switch lever and pull.
TO turn drill OFF ... Push lever in.
In an emergency; ...thedrill bit BINDS ...STALLS ..
STOPS . .. or tends to tear the workpiece loose . .. you
can QUICKLY turn the drill OFF by hitting the switch
with the palm of your hand.
TO lock switch in OFF position ... hold switch IN with
one hand ... REMOVE key with other hand.
WARNING: FOR YOUR OWN SAFETY, ALWAYS LOCK
THE SWITCH "OFF" WHEN DRILL PRESS IS NOT IN
USE ... REMOVE KEY AND KEEP IT IN A SAFE
PLACE ... ALSO ... IN THE EVENT OF A POWER
FAILURE (ALL OF YOUR LIGHTS GO OUT) TURN
SWITCH OFF ... LOCK IT AND REMOVE THE KEY.
THIS WILL PREVENT THE DRILL PRESS FROM
STARTING UP AGAIN WHEN THE POWER COMES
BACK ON.
I
HOLD
f
J
_2 REMOVING THE CHUCK.
7.
2=
Insert a piece of 5/16 in. dia. steel rod in one of
the holes in the chuck body.
Insert the CHUCK KEY into one of the holes in
the collar ,., turn it in the direction of arrow
until LOOSE. Continue to turn it until the chuck
is released.
LOCKING
COLLAR
CHUCK KEY
CHUCK SLEEVE
IN. ROD
OR DRILL
\
14