Filter
Top Products
9.Gentlypushdownon theFEEDHANDLESuntilthe
headraisesupwardsasfarasit willgo.
DONOTRELEASEFEEDHANDLE.
10,TIGHTENTHEHEADLOCKHANDLEANDTHE
QUILLLOCKHANDLE.
11.HOLDontothe FeedHandleandUNLOCKthequill
lockhandle.
12.LetthequillreturntotheUPpositioninthehead,
13.TIGHTENTHEQUILLLOCKHANDLE.
Repeatsteps3 thru 10until the headis raisedto the
desiredposition.PositionHEADSUPPORTCOLLAR
underneaththeheadandtightenthebolts.
HEAD
LOCK
HANDLE
LOCK
HANDLE
CAUTION:Do not raise the head above the top of the
coBumn.
HEAD EVEN
WITH TOP
OF COLUMN
SUPPORT
COLLAR
INSTALLING MOTOR PULLEY
When using a double shaft motor, remove the KEY from
the 5/8 in. dia, shaft.
2,
3_
Using a 5/32 in. setscrew wrench, UNSCREW the
setscrew in the pulley so that it is clear of the
KEYWAY (GROOVE).
Place the pulley on the shaft. Make sure it slips on
EASILY ... don't FORCE it. Remove any burrs in the
pulley or on the shaft if any.
Position the pulley so that the KEYWAYS in the shaft
and in the pulley line up; and the small end of the
pulley is about 1/16 of an inch away from the motor,