Filter
Top Products
assembly
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
1. Unwind the power cord.
2. Make sure the quill lock handle istight.
3. Stand on the left side of the drill pressand LOOSEN
the HEAD LOCK HANDLE.
4. Raise the HEAD about HALF WAY up the column.
CAUTION: THE HEAD WEIGHS ABOUT 70 POUNDS
DROPPING THE HEAD ACCIDENTLY COULD CAUSE
PERSONAL INJURY OR DAMAGE THE DRILL PRESS.
5. TIGHTEN the Head Lock Handle.
6. Position the HEAD-SUPPORT COLLAR underneath
the head and tighten the TWO BOLTS using a 1/2 in.
wrench.
HEAD
LOCK HAINDLE
I
HEAD SUPPORT
COLLAR
QUILL L'OCK
HANDLE
SPINDLE
NOSE
PACKING BLOCK
IN ORDER TO RAISE THE HEAD TO A HIGHER
POSITION, IT WILL BE NECESSARY TO INSTALL
SEVERAL PARTS.
INSTALLING THE CHUCK
Clean out the TAPERED HOLE in the chuck; clean the
spindle nose with a clean cloth. Make sure there are no
foreign particles sticking to the surfaces. The slightest
piece of dirt on the spindle nose or in the chuck will
prevent the chuck from seating properly. This will cause
the drill to "wobble."
6