Filter
Top Products
Fig.N
b ) and the. locking.handle (6) to the
ottom ot the set plate (4).
Fig. K 2
Front
Push stick (Fig. I, J)
Attach the metal push-stick storage
bracket (1) into the provided slots (2)
on the right side of the body shell.
The bracket will snap down into place.
Place the push stick (3) into the bracket
as shown in Fig. J.
4 _._-_--5
1 c_-_...._6
Anti-kickback pawls (Fig. L)
Storage for the anti-kickback pawls (1)
is located on the right side of the stand.
1. Take the anti-kickback pawl (1) and
slide the red locking knob (2) up
and press the anti-kickback pawl
down to secure the entire assembly
on the storage. Release the locking
knob (2).
Fig. L
Blade wrenches (Fig. J)
Insert the two blade wrenches into the
slot (4) located on the right side of the
saw housing, under the push stick.
Fig. J
6
INSTALLING THE BLADE GUARD,
ANTI-KICKBACK PAWLS AND
RIVING KNIFE STORAGE (Fig. K)
1. Attach the retaining clip (1) to the
stand (2) using two screws .(3).
Tighten .screws securely using a
screwarwer.
2. Attach the set plate (4) to the stand
(2) using two screws (3) and tighten
screws securely. Thread the washer
4
Blade guard assembly (Fig. L)
Storage for the blade guard assembly
is located on the right side of the stand.
1. Take the blade guard assembly (5)
and slide the locking knob (6) up
and press the guard assembly
down so that the entire assembly
is located on the set plate (4).
Release the locking knob (6).