Filter
Top Products
12._ ALWAYS WEAR EYE
U
PROTECTION. Any power
tool could throw foreign
objects into the eyes and cause
permanent eye damage. ALWAYS
wear Safety Goggles (not glasses)
that comply with ANSI Safety
standard Z87.1. Everyday
eyeglasses have only impact-
resistant lenses. They ARE NOT
safety glasses. Safety Goggles are
available at Sears. NOTE: Glasses
or goggles not incompliance with
ANSI Z87.1 could cause serious
injurywhen they break.
13. WEAR A FACE MASK OR
DUST MASK. Sawing
operation produces dust.
14. SECURE THE
WORKPIECE. Use clamps
or a vise to hold workpiece
when practical. It is safer than using
your hand and also itfrees both
hands to operate the tool.
1&DISCONNECT TOOLS FROM
POWER SOURCE before servicing,
and when changing accessories
such as blades, bits and cutters.
16.REDUCE THE RISK OF
UNINTENTIONAL STARTING.
Make sure switch is in the OFF
position before plugging the tool in.
17.USE RECOMMENDED
ACCESSORIES. Consult
this Operator's Manual for
recommended accessories. The use
of improper accessories may cause
risk of injury to yourself or others.
18.NEVER STAND ON THE TOOL.
Serious injury could occur if the
tool is tipped or if the cutting tool is
unintentionally contacted.
19.CHECK FOR DAMAGED PARTS.
Before further use of the tool, a
guard or other part that is damaged
should be carefully checked to
determine that it will operate
properly and perform its intended
function - check for alignment of
moving parts, binding of moving
parts, breakage of parts, mounting
and any other conditions that may
affect its operation. A guard or other
part that is damaged should be
properly repaired or replaced.
20.NEVER LEAVE THE TOOL
RUNNING UNATTENDED. TURN
THE POWER "OFF". Do not walk
away from a running tool until the
blade complete stop and the tool is
unplugged from the power source.
21.DO NOT OVERREACH. Keep
proper footing and balance at all
times.