Filter
Top Products
e o t m
know your loin er planer
2 or 3 turns with 1/2 in.-
LEVELING STUDS
LOCKSCREWS
VIEW LOOKING UP FOR PARTS IDENTIFICATION
Turning the LEVELING STUDS witf RAISE or LOWER
the infeed table.
\
SCREWING in the studs will RAISE the table . . .
UNSCREWING them wil_ LOWER the table.
ao With ;a 3/4 in. wrench turn leveling studs until
infeed table is parallel with straightedge,
i b, While hold ng studs with Wrench T1GHTEN all
• :fo0r LOCKSCREWS . .. tighten each screw a tittle
'bit at a time until ali four Screws are tight.
c. Recheck with straightedge to make sure infeed
table (in raised and lowered p0s t ons) is paratlel to
outfeed tablei
i i i
6.
ON-OFF SWITCH: It is unlikely that it will be
turned "ON" accidentally, when touched or bumped,
because of the way it is shaped.
" " t " n
In an emergency, it can betumed OFF bys rkl g
it with the palm of the hand.
The "yellow button" is a key, When inserted in the
switch lever, the power may be turned ON and OFF.
When it is removed, the power cannot be turned ON.
THIS FEATURE IS INTENDED TO PREVENT
UNAUTHOR IZED AND POSSIBLE
HAZARDOUS USE BY CHILDREN AND
OTHERS,
a. _lnsert Key into switch.
NOTE: Key {smade of yellow plastic,
_J
/
KEY
16