Filter
Top Products
laner operation
When planing wood 3/4 in, thick and NARROWER than
the hold down/push block, tilt the hold down/push
i block so that it ctears the top of the cutterguard while
feed ng.
Never plane wood that is thinner than 1/2 in .... because
it is apt to split or shatter and thus has a greater tenden-
cy tO kickbacki
BEY ELING
Adjust the fence to the desired angle ...tighten fence
and guard lock knobs,
Follow the same procedure for jointing or planing.
NOTE: Removing only the corner on the edge of a board
is known as CHAMFERING.
Normally a chamfer is made with one cut.,, therefore,
acut deePer than 1/16 in. may be made.
Use hold down/push blocks for wood under 3 in. wide.
PositiOn them so you have control of the workpiece at
all times: and so they do not contact the guard or the
cutter head,
CHAMFER BEVEL
NOTE: Rabbeting on a Jointer is consid_.red to be a
dangerous operation because it requires removal of the
cutter guard and increases the potential of kickback be-
cause of excessive depth of cut,
NEVER ATTEMPT TO PERFORM A RABBETING
OPERATION ON THIS JOINTER. DO NOT OPERATE
JOtNTER/PLANER WITH CUTTERHEAD OR BELT
GUARDS REMOVED.
Rabbet cuts should be made on the Radial Saw or Table
Saw b_ making two cuts with the sawblade or by using
tbe,Dado Head or Molding Head. Rabbet cuts can also
be made using the Shaper or Portable Router.
RABBET CUT
2O