Filter
Top Products
" . i .: i " • • o n
trouble shooh g
ETY, TURN SWITCH
:ROM POWER SOURCE
SHOOTING YOUR JOIN-
TROUBLE i
Motor will not run.
'r ::
TROUBLE SHOOTING CHART
PROBABLE CAus'E .........
I. DefectiveOn-Off switch.
Defectiveswitchcord.
Defectiveswitchbox receptacle.
2. Motor protector open, (only if
your motor isequipped with an
overload protector).
REMEDY
1. Replace defective parts before using
machine again.
2. Consult Sears Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified service
Wood strikes outfeed
table after passing over
cutter head.
Ripples on planed
surface:.
' Other cause
Blades improperly adjusted below
surface of outfeed table,
1, One blade set higher than other.
2. Feeding wood too fast.
Planed surface not: Infeed table out of adjustment.
technician. Repair service is available at your
nearest Sears Store,
F
Re-adjust biades, see Maintenance section.
| , ,, ,=m_l,=,l
1. Re-adjust blades, see Maintenance
section.
2. Feed wood slower.
i ,
Re-adjust infeed table, see Getting To Know
your Jointer Planer section.
Excessive gouging at end Blades set too high above outfeed Reset blades, see Maintenance section.
of Cut. : - : . table,
90 ° and 45 °cuts !, Fence stops not adjusted properly. ! !. Re-adjust fence stops see Getting To
inaccurate. ' J ' Know your Jomter Planer sect=on.
2_ Fence slide bracket not even with 2. Re-adjust slide bracket, see Getting To
Know your Jointer Planer section.
lnfeed table loose. I. Dovetail spacer requires adjustment. 1. Tighten screw, key t0, see fig. 2, Parts List.
2, Female dovetail loose from table. 2. Tighten screws, key 18, see fig. 2, Parts List.
i i
Cutter guard does not I 1. Return spring: broke,, Or sprin 9 " 1. Replace spring immediately. See
function properly, has been weakened. Maintenance section.
2. Improper assembly of spring or 2, See Maintenance section.
guard mounting.
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Legs ............................... 9-22245
Floor Stand ............................. 9-22216
Cutter B_ades .............................. 9-2293
Power Tool Know-how Handbooks
Radial Saw .............................. 9,2917
Table Saw .............................. 9-2918
Knife Setting Gauge ........................ 9-2647
Chip Collector ............................ 9-29977
The above recommended accessortes are current and were
available at the time this manual was printed.
26