Filter
Top Products
parts, find the following
18 x 3/4
x2
7 Washers; 11/32 ID
7 Hex Jam NUts, 5/16-18
2 Cord Clips
2. Loosen FENCE LOCK KNOB. Tilt fence upward and slide
J_toward the pulley.
3. Position machine on Leg Set and align mounting holes
m machine with holes in Leg Set letter coded "'A".
Mount with three (3) 5/16-t8 x 2" Long Hex Head
Screws.
_ JO|NTERfPLANER
_HEX HEAD SCREW
FLATWASHER--- ST|FFENER
LOCK WAS H E R .-""_::]
HEXNUT
FENCE LOCK
KNOB
1-1t4 IN. SCREW
4. Place a flat washer, a lock washer and a nut on each
screw from underneath the stand and tighten.
5. Place handwhee] on shaft aligning flat surfaces on shaft
with flat surfaces on handwheel _.. attach with 1-1/4
In. screw,
114-20 TRUSS SIDE STIFFENER
HEAD SCREW
/
o ! / ...._o o
o B B o
°_A END STIFFENER o
0 _ _ 0
o : : _ A o
-,_ -Q. 7_---_- ...... _o_.D-
-- MOTOR SUPPORT AT THIS END
I
I
I
I
DEPTH OF CUT
_DWHEEL
CHECKING-CUTTER: BLADES AND SCREWS
TOOLS NEEDED
5/32" and t/8" Setscrew Wrenches (furnished with
Jointer).
Lead Pencil
Short straight edge (or head of combination square)
OUTFEED TABLE
WEDGE
5/32 IN. SETSCREW
WRENCH
1. tnsert pencil in space at end of cutterhead to hold
cutterhead guard open.
2. Lower the infeed table with the Depth of Cut
Handwheel.
3. Rest the straight edge on edge on the surface of outfeed
table so it extends across the opening between the
tables, at three positions: near each end and at the
middle of the cutter blade.
4. Rotate the cutterhead by grasping the 2" alia. driven
pulley and make sure each knife nicks (touches) the
straight edge at a ! three post on:s tf not f0 ow
p ocedure unde REPLAC NG CUTTER BLADES on
ppg. 21 and 22.
BLADE
PENCI L
CUTTER GUARD
5. If a cutter blade adjustment _s not required, check each
locking screw of each wedge 15/32" setscrew wrench)
and tighten if necessary, Hold the pulley while
tightening screws and be careful that your f'ngers do not
slip off the wrench,"