Filter
Top Products
PRODUCTSPECIFICATIONS
Chuck........................................... 3/8 in. (10 ram) Keyless
Motor.............................................................. 14.4 Volt DC
Switch ....................................................... Vadab[e Speed
Gear Train ............................................................. 1 Speed
No Load Speed ................................................. 0-6501min.
KNOW YOUR DRILL-DRIVER
See Figure1,
Before attempting to use yourddll-ddver,familiarize
yourselfwith alloperatingfeatures and safety
requirements.
WARNING: Carefully read throughttdsentire
operator'smanualbefore usingyour new dhlt-dr'rvar.
Pay closeattentionto all Salety Rules, Warningsand
Cautions. It you use your drill-driverpropertyand
only forwhat it Is Intended,you will enjoy yearsof
safe, reliable service.
,_ WARN|NG: Do not allowJamiliaritywithyour rid}l-
driverto make you careless. Remember that a
careless tractiono1a second Is suff_em to Inflict
severe injury.
KEYLESS CHUCK
Yourdrift-driverhasa keylesschuckthatallowsyouto hand
_ghten or releasedrillbitinthe chuckjeers.
DIRECTION OF ROTATION SELECTOR
FORWARD/REVERSE
Yourdrill-driverhas a forward/reverseselector located
above t_e sw}tchtrigger.The sw_chtdggercan be locked
inthe OFF position.
C[utoh............................................................... 4 Positions
Charger input........................_........ 120 V. 60 Hz, AC only
Charge Rate ....................................................... 3-6 Hours
Torque.................................................................... 90 In.lb.
SWITCH TRIGGER
Toturn your drill.driverON, depressthe switchtrigger.
Release switchtrigger to turnyour drill-driverOFF.
VARIABLE SPEED
This toolhasa variable speed switch that delivershigher
speed withincreasedtriggerpressure.Speed is controlled
by the amount of switchtdggerdapmse)on.
BIT STORAGE
When not In usa, bitspro'tidedwith yourclflfl-drivarcan be
placed _ the storage area locatedon the top of the motor
housing.
TORQUE ADJUSTMENT RING
Your drill Is equippedwith an adjustabletorquerk'vgfor
drivingdifferenttybes of screws intod_farentrnaterials.
The proper settingdependson the type of material and
the size of the screw you are using.