Filter
Top Products
MAINTENANCE
DEPTH ADJUSTING RING
ADJUSTMENTS OR REPLACEMENT (Continued)
5. Remove two screws on front of depth adjusting ring. Also remove slide nut from pocket inside clamping lever. NOTE;
Depth adjusting ring replacement Is the only time bottom screw should be removed.
6. Remove depth adjusting ring.
7. Position new depth adjusting ring in place and secure with the same screws and slide nut used to secure old depth
adjusting ring.
8. Make all adjustments with top screw (#10-32 x 15/16 In. Fil. Hd.) as mentioned previously. Bottom screw (#6-19 x
1/2 In. Pan Hd.) should have up to a maximum 114In. (.250) clearance, allowing flexibilityfor top screw adjustments.
See Figure 19.
ACCESSORIES
'-"-- THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENT AND WERE
AVAILABLE AT THE TIME THIS MANUAL WAS PRINTED.
DovetailTemplate
BoxJointTemplate
Mill-WorksMoldingMaker
Bis-KitPlateJointerKit
Multi-PurposeRouterGuide
(9-2579) TemplateGuideBushings (9-25082)
(9-2580) Rout-A-FormPantograph (9-25187)
(9-25254) TemplateSet (9-2573)
(9-25423) SharpeningKit (9-66501)
(9-25179) FullView RouterBase (9-25086)
COMBI. VEINING
NATION BITS
PANEL
CUTTER
28330-1/11"
26329-3/18"
II
DOUBLE END
2_-1N" ; 48". 60"
• 251641-3/8" V-GROOVE
263,13
COREBOX
BIT
26326`114"
26326-1/2"
V-GROOVEI
2_!22-1/2"
"26r/11-1/2-
STRAIGHT COMB-
FACE NATION
BITS STRAIGHT,
cm'n_
I '1)
26317-1/16"
®
26316-1/11" FORFORMICA
28316`1/4" "2541
26314-_t/3"
26313-1/2"
2631:;1-3/4"
"25524°1/4"
"26528-5/16"
"25826`.3/6"
°2"3627-1/2"
°25606`,1/4"
HINGE DOVETAIL RABBET OGEE COVE
MOR11_NG CttlTI_ BIT BIT
BIT BITS
3/16" 26301-3/8"
26300-1/2"
26306
"25576-3/6"
'25575-1/2"
VENEER 1/4",S/16",ROMANO 45°
CUTTER 3/8" 20304-5/32" CHAMFER
1/2" 2_13-t/4. 2630_1/4. BIT
STRAIGHT 26336 26313-1/2" 26310
°25413 "25507-.5/32"
"26582 26303
BEVEL "25504-114"
°25412 I' " *CARBIDE TIPPED'BITS I
BEAD ARBOR
OUARTER-
ROUND =r_m
BITS
26306`I/4"
26308-3/8" WITH 2
26307-1/2" BALL
BEARINGS
"26503-1/4" (1/2[ & 5/8")
*25_dS6`3/8" *25895
"25565-1/2"
The use of attachments or accessories not listed above might be hazardous.
Page 13