Filter
Top Products
-11-
Figure 3.
Assembled Legs.
Figure 4. Installed braces.
Figure 5. Remaining legs and
braces installed..
The Model W1717 Sander mounts onto a heavy
duty metal work stand. This assembly will be
fastened together using the supplied M8-1.25 x
12 carriage bolts, 8mm washers and 8mm hex
nuts. Finger tighten the hardware at this time.
To assemble the work stand, do these steps:
1. Assemble two legs together with a lower
short brace and an upper short brace as
shown in Figure 3.
2. Install the long upper and lower braces to
the assembled legs as shown in Figure 4.
3. Attach the remaining legs and short upper
an lower braces as shown in Figure 5.
4. Slide the rubber feet onto the bottom of
each leg to complete the stand assembly.
Stand Assembly