Filter
Top Products
-15-
The motor mounting plate can be adjusted to
correctly position the main roller in relation to
the platen.
To adjust the main roller position, do these
steps:
1. UNPLUG THE SANDER!
2. Loosen the four motor mounting bolts
(Figure 12).
3. Remove the sanding belt.
4. Place a straightedge against the platen and
check the roller clearance along the top and
bottom. The roller should be
1
⁄8" behind the
platen. Figure 13 shows a top view of the
proper clearance.
5. Tighten the motor mounting bolts when the
proper clearance has been achieved.
Figure 13. Proper platen to roller alignment.
Figure 12. Motor mounting bolts
(only 2 shown).
1
⁄8
"
Roller Adjustment
Platen
Roller