Filter
Top Products
The purpose of a test run is to identify any
unusual noises and vibrations, as well as to con-
firm that the machine is performing as intended.
To test run the Model W1717, do these steps:
1. Make sure all guards are in place and the
belt is tracked and tensioned properly.
2. Make sure that the ON/OFF switch is in the
“OFF” position before connecting the
machine to power.
3. Pull the power switch up to start the
sander. Once the sander is running, listen
for any unusual noises. The machine should
run smoothly with little or no vibrations.
• If there are any unusual noises or vibra-
tions, STOP the sander immediately by
pushing the paddle switch down.
4. Unplug the sander and investigate the
source of the noise or vibration. DO NOT
make any adjustments to the sander while it
is plugged in. The sander should not be run
any further until the problems are correct-
ed.
This machine produces
sawdust that may cause
allergic reactions or res-
piratory problems. Wear
a respirator in addition to
using a dust collector.
THIS MACHINE creates
sawdust. Always wear
safety glasses or a face
shield during all sanding
operations.
KEEP loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
-16-
Test Run
OPERATIONS