Filter
Top Products
-19-
Figure 19. Contour sanding operation.
Curves and profile sanding operations can be
sanded on the contour table.
To start a contour sanding operations, do
these steps:
1. UNPLUG THE SANDER!
2. Loosen the lock knobs in Figure 18 to adjust
the contour table height to the desired posi-
tion. Note— Keep enough of the table post
in the bracket so the adjustment knobs can
make contact.
3. Tighten the lock knobs to secure the table.
4. Plug the sander into the power supply.
5. Start the sander.
6. Hold the workpiece firmly with both hands
and feed it into the curved end as shown in
Figure 19. Move the workpiece around the
end until the desired profile is achieved.
Figure 18. Height adjustment knobs.
Contour Sanding