Filter
Top Products
Df[\cN(/)+('?pYi`[KXYc\JXn
-21-
J<KLG
Once the assembly is complete, test run the machine to
make sure it runs properly for regular operations.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety
disabling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review Troubleshooting on Page 72.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine, do these steps:
1. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is set up properly.
2. Ensure all tools and objects used during setup are
cleared away from the machine.
3. Connect the machine to the required power source
(see Page 10).
4. Verify that the machine is operating correctly by
turning the machine FE.
— When operating correctly, the machine runs
smoothly with little or no vibration or rubbing
noises.
— Investigate and correct strange noises or vibrations
before operating the machine further. Always
disconnect the machine from power when
investigating or correcting potential problems.
5. Turn the machine F==.
6. Insert the switch disabling pin through the green ON
button, as shown in =`^li\)-.
7. Press the ON button to test the disabling feature on
the switch.
— If the machine does not start, the switch disabling
feature is working as designed.
— If the machine starts, immediately stop it. The
switch disabling feature is not working correctly.
Call Tech Support for help.
Te s t R u n
=`^li\)-% Switch disabling pin inserted
into ON button.
ON / START
Button
Pin
OFF / STOP
Paddle
Recommended
Adjustments
For your convenience, the adjustments
listed below have been performed at the
factory and no further setup is required to
operate this machine. However, because of
the many variables involved with shipping,
we recommend that you verify the
following adjustments to ensure that this
saw cuts safely and accurately. Step-by-step
instructions for these adjustments can be
found in the SERVICE section.
Adjustments that should be verified:
• Blade tilt stop accuracy (Page 58).
• Spreader/riving knife alignment
(Page 63).
Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\
Zflc[ ZXlj\ j\i`flj \p\ `ealip% N\Xi
jX]\kp ^cXjj\j kf i\[lZ\ k_\ i`jb f]
`ealip%