Filter
Top Products
28
Unpacking and Checking
Contents
Before moving the saw: Lock the miter
lock knob in 45° left or right position. Lock
b
evel lock handle. Lock head assembly in the down position.
Never carry the tool by the cord or head assembly power
s
witch handle. Damage to insulation could cause an electric
shock. Damage to wire connections could cause a fire.
Model 3800 Compound Miter Saw is shipped complete in one
box.
1. Separate all parts from packing materials and check each
one with the “Table of Loose Parts” to make sure all items
are accounted for before discarding any packing material.
2. Loose parts:
•
Vertical Clamp - Provides fast clamping of workpiece.
• Hex Wrench (2)- Stored behind sliding fence.
• Miter Lock Knob
• Dust Bag & Elbow
• Extension Rail
• Extension Table with Thumbscrew
• Stop Block
• Operating/Safety Instructions
If any parts are missing, do not plug in
power cord or turn the switch on until the
missing parts are obtained and are installed correctly.
Installation of Miter Lock Knob
1.
Locate Miter Lock Knob from Loose Parts.
2.
Assemble Miter Lock Knob into front of Table as shown
(Figure 1).
Do Not Over Tighten.
Assembly
FIG. 1
WARNIN
G
!
CAUTION
!