Filter
Top Products
58
Saw Operations
•
Base molding can be cut vertical against fence or flat on
the table.
•
Follow the table for helpful hints on cutting base molding.
Base Molding
BASE MOLDING CUTTING INSTRUCTIONS
SETTINGS Vertical Position Horizontal Position
/ Back of molding is Back of molding is flat
INSTRUCTIONS against the fence on the table
Sliding Fence
Far Right Position Move to proper position
Bevel Angle
0° 45°
Molding position
Left Side Right Side Left Side Right Side
Inside Miter Angle Left at 45° Right at 45° 0° 0°
corner of wall
Molding
Bottom Bottom Top against Bottom
position
against table against table fence against fence
Finished Keep left Keep right Keep left Keep left
side side of cut side of cut side of cut side of cut
Outside Miter Angle Right at 45° Left at 45° 0° 0°
corner of wall
Molding
Bottom Bottom Bottom against Top against
position
against table against table fence fence
Finished Keep left Keep right Keep right Keep right
side side of cut side of cut side of cut side of cut
Left
Right
Right
Left