Filter
Top Products
38
Adjustments
Blade Square to Fence
1
. Lower the head assembly and push in the lock pin to lock
in the lower position. Make sure table is in 0° detent and
tighten miter lock knob. Place a combination square
1
a
gainst the fence
2 a
nd next to the blade
3 a
s illustrated.
Locate the square properly so it does not contact the
tooth of saw blade. The saw blade should contact the full
l
ength of the square (Figure 10).
2. If blade does not contact the square, follow the fence
alignment procedure.
Fence Alignment
a. The head assembly should remain in lowered
position.
b Move sliding fence to proper position. (See Sliding
Fence on page 50.)
c. Using the supplied large hex wrench, loosen
the three (3) hex cap screws
4 behind fence 5
(Figure 11).
d. Adjust fence until blade and the fence has full
contact with the square.
e. Tighten hex cap screws.
FIG. 10
1
2
3
FIG. 11
4
4
5