Filter
Top Products
52
Miter Cut
•
A miter cut is made at 0° bevel and any miter angle in the
range from 52° left to 52° right.
•
The miter scale is cast-in on the base for easy reading.
• Positive detents have been provided for fast and accurate
m
itering at 0°, 15°, 22.5°, and 45° left and right.
•
There is also a crown molding detent at 31.6° (see
Cutting Crown Molding for more information page 65).
•
For maximum support, the sliding fence must always be
as close to the blade as possible without interfering with
head assembly. (see Sliding fence adjustment, if
necessary, page 50).
• For precision settings, use the detent override to lock out
the detent.
Follow these instructions for making your miter
cut:
1. Loosen miter lock knob 1. Lift miter detent trigger and
move the saw to the desired angle, using either the
detents
2 or the miter scale 3. Tighten miter lock knob
(Figure 26).
2.
Properly position workpiece
4. Make sure workpiece is
clamped
5 firmly against the table and the fence.
Use clamping position that does not
interfere with operation. Before switching
on, lower head assembly to make sure clamp clears guard
and head assembly.
3. Activate the switch. Lower the head assembly and make
your cut.
4. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
Saw Operations
FIG. 26
WARNING
!
1
2
3
5
4