Filter
Top Products
40
Adjustments
Miter Scale (Vernier) Indicator
Adjustment
1. Raise the head assembly to the full-up position.
2. Loosen the Phillips screw
1 that holds the indicator 2 in
place (Figure 12).
3. Position the indicator
2 to align with the 0° miter mark 3.
Tighten the screw
1.
Laser Alignment System
Your miter saw is equipped with a laser alignment system to
help identify where the blade will contact the work piece. The
laser line has been adjusted to the center of the blade. You
should make a practice cut into a scrap piece of wood so you
know exactly where to place your workpiece.
The tool power cord must be plugged in, but you do not have
to activate the trigger to use the laser. The laser alignment
system can be turned on or off by using the switch
24 shown
on page 8.
FIG. 12
1
2
3