Filter
Top Products
54
Bevel Cut
•
A bevel cut is made at 0° miter and any bevel angle in the
range of 0° to 47°.
•
There are two (2) factory set bevel stops at 0° and 45°.
(See Adjustment section if adjustments are required.)
•
The bevel scale faces the operator for easy reading.
•
The bevel lock handle is spring loaded and can be
repositioned by pulling handle out, rotating to desired
position and engaging by releasing for use in tight
spaces.
• Use sliding base/fence as appropriate. (See Sliding
Base/Fence Extension page 50.)
Follow these instructions for making your bevel
cut:
When bevel cutting remember to “lock”
cutting head in every position before
proceeding, so head does not unexpectedly shift in use.
1. Move the sliding fence to proper position
1. (See Sliding
Fence on page 50.)
2. Loosen the bevel lock handle. Tilt the head assembly to
desired bevel angle
2. Tighten the bevel lock handle
(Figure 27).
3. Properly position workpiece
3. Make sure work piece is
clamped
4 firmly against the table and the fence 5.
Use clamping position that does not
interfere with operation. Before switching
on, lower head assembly to make sure clamp clears guard
and head assembly.
4. Activate the switch. Lower the head assembly and make
your cut.
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
Saw Operations
FIG. 27
3
4
0
°
1
WARNING
!
WARNING
!
See Warnings on page 5
Voir les avertissements à
la page 13
Consulte las advertencias
que están en la página 21
2