Filter
Top Products
14
Logon to Appliance – Configuring User Level Authentication Settings
This is the other method of authenticating users, and requires the user to login to the appliance. Please refer
to the following paper for more details on ULA:
http://www.sonicwall.com/downloads/SonicOS_Standard_2.1_User-Level_Authentication.pdf
In this example, the LAN zone will be configured for ULA:
Step 1: Go to Network>Interfaces>X0 (or appropriate interface).
Step 2: Under General enable HTTPS User Login. Also enable Add rule to enable redirect from
HTTP to HTTPS if neither HTTP Management nor HTTP Login are enabled (it is not needed if either
of them are).
Step 3: Go to Firewall>Access Rules>LAN>WAN. The default is set to: ‘Any, Any, Any, Allow’ rule,
shown below.