Filter
Top Products
Applications and Setups 5
DG711 and DG511 Pipe Laser User Guide 43
1211 Laser Plummet
Line Setting
5.4.8
The laser plummet may be used in
place of the Plumb-bob by
attaching it under the tripod or
manhole mount.
1 Position the laser plummet over
the laser’s bull’s-eye reflective
target into the manhole mount or
tripod replacing the 5/8 x11
attachment thread.
2 Quickly turn the product upside
down to activate the compensator
and turn the power switch "on".
3 If the bull’s-eye target cannot
be seen, align the Laser Plummet
to the plus sign on the positive
grade button on the keypad or
anywhere along the center of the
laser.
4 In an over-the-top setup, set the
laser on a tripod and align the
Laser Plummet over the first grade
stake.
Second Far-Point
Alignment
5.4.9
1 Simultaneously press both Left
and Right Line buttons to center
the laser’s ±10° of line travel.
2 Press either Line button to align
the laser beam to the second
control point. If using a wireless
remote control, point the remote
towards the laser and press the
appropriate line button.
Note – Line speed increases the
longer you press the line button. To
slow the line speed, release the line
button then press again.
Next manhole