Spectra UL633-1 Laser Level User Manual


  Open as PDF
of 31
 
10
4.PressandreleasetheMENUbuttonattheStandardDisplayandselectAxisAlign.
5.Selectthedesiredaxisthenpressbutton4tostartAxisAlign.
Note:AdjustingthereceiverintothebeambeforestartingtheautomaticAxisAlignmentreducesthetime
neededfornishingthealignment.
Selecting the menu icon „View Axis Angle“showsthealignmentangleafteranaxisalignmenthasbeen
completed. This function can be used to measure an angle difference between two direction hubs in a range
uptomax.80°byperformingtwoaxisalignmentsinsequence.
The menu icon „Axis Angle Input“selectionallowstodialinanaxisanglewheretheaxisdirectionwillbe
alignedtooafterarstaxisalignmenthasbeendone.Tworowsareavailablefortypinginaxisanglevalues.
Button5 and 8canbeusedtotogglebetweenbothrows.Changingthesignandnumberscanbedoneusing
the buttons 1 and 2.
Press and release button 4
toconrmtheselectedaxisangles.Theaxeswillbeadjustedwhilethedisplay
fallsbacktothemainMenu.
Press and release button 3(ESC)toexittheAnglefunctions.
Manual Spot Search mode
The Spot Search mode is used for detecting the plumb beam manually using the Spot Finder
SF601andcanbeactivatedinhorizontalandverticalautomaticandmanualmode.
PressandreleasetheMENUbuttonattheStandardDisplayandselectSpotSearch.
Pressing button 4activatesthefanbeamwhiletherotationspeedchangesto900rpmandthe
unit goes back to the standard display.
The4redLEDsaroundthecenterholeguidetheusertotheplumbbeam‘scenterposition-all4LEDson=>
conrmationtheSF601hasbeensettothecorrectcenterposition.
Note:ManualSpotSearchcanalsobeactivatedanytimebyturningontheSpotFinderSF601.
TurningOfftheSF601deactivatestheSpotSearchmodeimmediatelybydeactivatingthefanbeam.
Activating/Deactivating Standby mode
PressandreleasetheMENUbuttonattheStandardDisplayandselectStandby.
Pressing and releasing button 4 activates the Standby mode.
Theself-levelingwillbestoppedandthebeamwillbeturnedoffwhiletheHIalertisstillactive.
ThedisplayshowsthestandbysymbolandtheLevel/StandbyLEDashesredevery5seconds.
To deactivate Standby mode and restore full operation of the laser, press and release button 4.
111560trimble_UL633_01_GB.indd 10 19.01.12 13:24
 previous next