Spectra UL633-1 Laser Level User Manual


  Open as PDF
of 31
 
15
Pairing the transmitter with remote control
The chain symbol at button 1 indicates the remote has never been paired before which means no radio
connectivity is given. Pressing the pairing button 1willinitiateapairingrequest.Thetransmitterhastobein
pairing mode as shown above.
Note:Makesurethatpairingmodeisselectedonlyatonetransmitterwhichiswithintheradiorangeofthe
remoteduringapairingrequest.Otherwisepairingprocedurecanbeconfused.
Pairing the transmitter with receiver
To pair the transmitter and the receiver select Settings and press and release button 4 to open the Pairing
menu.Thedisplayshowsthecurrentlypairedunits(upto2receivers).Ifalready2receivershavebeenpaired,
one or both of them have to be deleted using button 1(CLR).
A
B
C
Next,turnonthereceiverthenpressandholdtheDeadband(A)andtheAudio(B)buttonsfortwoseconds.
AftertwosecondsthedisplayshowsMENUrst,thenRDIO.
PressandreleasetheUnits(C)button–displayshowsthecurrentradiomode.
IfnotalreadysettoUL,pressUnitsbuttonandthenpressDeadbandorAudiobuttonuntilULisdisplayed.
PressUnitsbuttonagaintoenterselection.PressandreleasetheAudiobutton–displayshowsPAIR.Press
theUnitsbuttonagain–thedisplayshowsPAIRandarotatingbar.AftercompletingPAIR,OKwillbedisplayed.
TheUL633pairsnowautomaticallywiththenewreceiver.PressandreleasethePowerbuttontwotimesto
exitthemenu.AlasersymbolislittoconrmthereceiverworksinULmode.
Mask mode
SelecttheMaskiconandpressandreleasebutton4toopentheMasksettingmenu.Depending
onwhichsideorcornerthebeamshouldbeturnedoff,therequiredsectorcanbeselected.Press
and release the buttons 5 to 8formovingashortashinglinearoundthemaskmodesymbol.For
selectingthesectorwherethebarisashing,pressandreleasebutton1(SET).Aftersettingthe
rstsector,button1changestoshowCLRwhichofferesthecapabilityofdeletingtheselectedmask
sectoragain.Usebutton5 to 8tomovetheashingbartootherrequiredareasandrepeatthesettingprocess.
Whenallareashavebeenset,pressbutton 4 to store the mask sector selection until the unit will be turned off.
Hinweis: The unit always powers up with the mask mode deactivated (default).
111560trimble_UL633_01_GB.indd 15 19.01.12 13:24
 previous next