Filter
Top Products
DS06 User Manual ◄ 17
5. Apply a few drops of oil to the rivet hub (Figure 22).
Figure 22. Applying the Oil
6. Turn the spinner crank while slowly running the take-
up handle inward (approximately one full revolution)
until the rivet head is formed (Figure 23).
NOTE:
The take-up handle provides pressure while the
spinner anvil forms the rivet head.
Figure 23. Forming a Rivet Head
Figure 24. Spinner Oiling Chambers
NOTE:
The rivet spinner is equipped with oiling chambers
and should be maintained periodically with a light-
weight oil (Figure 24).
NOSE SPROCKET DISASSEMBLY
AND ASSEMBLY
1. Using the bench mounted chain breaker (see acces-
sories), line up the 1/4 inch hole in the side of the
chain breaker anvil with the chain breaker punch.
Punch out the six nose sprocket rivets. See Figure
25.
Figure 25. Punching Out Nose Sprocket Rivets
2. Insert a straight blade screw driver to spread the
bar nose rails just enough to remove the old nose
sprocket. Use a rag or paper towel to clean the nose
sprocket area. See Figure 26.
Figure 26. Removing Old Nose Sprocket
MAINTENAN & ADJUSTMENTS