Stow SFCS-16 Sander User Manual


 
ASSEMBLY INSTRUCTIONS/OPERATION
SFCS-16 OPERATION AND PARTS MANUAL REV #3 (02/23/06) PAGE 15
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
1) Properly disconnect the extension cord or the
FLOOR COVERING SCRAPER from the power
source.
2) To place the operator handle in the work position,
move the handle upright so that the ball-detent pins
can be inserted through the operator handle and main
frame. Determine the ball-detent pins are inserted
through the operator handle and main frame to fully
expose the ball detent. FIGURE 9.
FIGURE 9
THE BALL DETENT MUST BE FULLY EXPOSED
AGAINST THE MAIN FRAME TO PROVIDE THE
PROPER PIN RETAINING FORCE. AN IMPROPER
PIN RETAINING CONFIGURATION CAN RESULT IN
UNEXPECTED OPERATOR HANDLE MOVEMENT.
THIS OCCURRENCE CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
3) Loosen the threaded handle knobs and extend the
operator handle out until the internal handle stops
thrust against the threaded studs. Retighten the
knobs. FIGURE 10.
FIGURE 10
CAUTION
Improper knob tension and/or improperly securing
the operator handle to the main frame can result in
an unstable platform configuration. An unstable
platform configuration can result in property
damage and/or personal injury.
4) Tilt the FLOOR COVERING SCRAPER back until
the operator handle comes in contact with the surface.
The FLOOR COVERING SCRAPER may not be in a
stable position in this configuration. To minimize the
possibility of property damage and/or personal injury,
properly secure an appropriate weight to the handle
for added stability. Other means can also be utilized to
support the frame and provide proper machine
stability. Appropriate wheel chocks are also
recommended. FIGURE 11.
EXERCISE EXTREME CAUTION WHEN WORKING
NEAR OR UNDER THE FLOOR COVERING
SCRAPER WITH THE OPERATOR HANDLE TILTED
BACK IN THE SERVICE POSITION. IF THE FLOOR
COVERING SCRAPER IS NOT POSITIONED IN A
STABLE CONFIGURATION, WITH ADEQUATE
COUNTERWEIGHT PROPERLY SECURED,
UNEXPECTED MOVEMENT CAN ALLOW THE
MACHINE TO FALL BACK TO THE WORK
SURFACE. THIS OCCURRENCE CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL
INJURY.
FIGURE 11
DANGER
DANGER