Filter
Top Products
ASSEMBLY INSTRUCTIONS/OPERATION
SFCS-16 OPERATION AND PARTS MANUAL REV #3 (02/23/06) PAGE 30
b) To lubricate the exciter bearing housing casting.
The exciter unit utilizes a sealed type ball bearing. The
Zerk® fitting provides lubrication for the self-aligning
feature of the bearing unit. Consult the LUBRICATION
section for additional information.
Sleeve type bearings are self-lubricating and will not
normally require additional lubrication during their
normal service life. Ball type bearings are shielded or
sealed and will not normally require additional
lubrication during their normal service life.
9) Determine that all safety decals and operational
information decals (including the applicable Quik Tips
information) is in proper and readable condition.
Replace any missing or damaged safety decal and/or
information decal with a factory approved replacement
part only.
10) The FLOOR COVERING SCRAPER utilizes
antivibration handle grips on the operator handle to
enhance control and help dampen the forces
experienced during the covering removal process.
Determine the handle is equipped with properly fitting
handle grips of sufficient integrity to allow for proper
job function as outlined in this manual. Loose fitting
handle grips or grips without end caps should be
replaced with factory approved replacement parts
only.
DANGER
DO NOT OPERATE THE FLOOR COVERING
SCRAPER WITHOUT PROPERLY FITTED HANDLE
GRIPS OF SUFFICIENT INTEGRITY INSTALLED
ON THE OPERATOR HANDLE. OPERATING THE
FLOOR COVERING SCRAPER WITH IMPROPER
OR NO HANDLE GRIPS CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL
INJURY.
LUBRICATION REQUIREMENTS.
Parts Required:
1 each, standard grease gun filled with one of the
following: ESSO Beacon 325, Shell Alvania #2,
Chevron SRI, or equivalent.
1 each, container of dry film lubricant.
1) Lubricate the caster wheel bearings with a dry film
lubricant only. Dry film lubricants dry immediately
upon contact. Use sparingly. Excess lubricant will
attract the fine grained, powdered materials
described and directly affect bearing service life.
CAUTION
Do not lubricate the caster wheels with any
lubricant other than a dry film type. Grease and
many other liquid type lubricants will attract
foreign material accumulations that can reduce
bearing service life.
2) Zerk™ type grease fittings are provided at two
locations:
a) To lubricate the Back Saver™ Blade Control
System jackscrew. Keep the jackscrew properly
lubricated to minimize friction when operating the
blade control lever. Excessive lubrication will attract
foreign material accumulations that can reduce
jackscrew service life.
FIGURE 32.
b) To lubricate the exciter bearing housing casting.
The exciter utilizes a sealed type ball bearing. The
Zerk® fitting provides lubrication for the self-aligning
feature of the bearing unit. FIGURE 33. Grease
interval will vary depending upon machine utilization
rates and operating environment factors.
Sleeve type bearings utilized for the operator handle
are self-lubricating and will not normally require
additional lubrication during their normal service life.
Ball type bearings are shielded or sealed and will not
normally require additional lubrication during their
normal service life.
FIGURE 32