Wagner SprayTech 525 Paint Sprayer User Manual


 
GB
9
TexPerfect Flexio 525
13. Adjusting the Material Volume (Fig. 6)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
lower material volume  turn anti-clockwise (-)
higher material volume turn clockwise (+)
14. Setting the Amount of Air (Fig. 7)
i
Depending on the viscosity of the material to be sprayed and the nish of the
object to be coated, it may be advisable to vary the amount of air. Very low viscosity
materials do not have to be atomised with the maximum amount of air. In this case it
is advisable to reduce the amount of air and thus minimize the spray vapour.
This also applies for the use of the low-scale and radiator/detail spray attachment
(accessory).
Turn the air quantity regulator (g. 7, 1) until the level you want is above the arrow.
thin paint
Level min to 6
thick paint (e.g. interior wall paint)
Level 6 to max
15. Spray Technique
General
i
The spray result depends heavily on the smoothness and cleanliness of the
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
Cover all surfaces not to be sprayed.
i
Important: Start at the edge of the area to be sprayed. Start the spray
movement rst of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation.
Fig. 8 A: CORRECT Even distance to the object.
Fig. 8 B: INCORRECT An uneven distance will result in uneven paint application.
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
An even movement of the spray gun results in an even surface quality.