Wagner SprayTech 558054 Paint Sprayer User Manual


  Open as PDF
of 32
 
12 ProSpray 3.39
GB
Starting operation Spraying technique
Security Code Screen
SECURITY CODE
CHANGE-2MENU-1
The Security Code screen allows the user
to set a four digit security code to prevent
unauthorizeduseofthesprayer.Ifasecuritycodehasbeenset,the
control system display will ask for the code at startup. If the correct
code is entered, the display will show the Main Screen and the
sprayer will operate. If the wrong code is entered, the display will
continue to ask for the correct code and the sprayer will be disabled.
To set or change the security code, press the #2 key.
i
If the sprayer is new, no security code is set and the
Main Screen will appear at startup. When setting a
security code for the rst time, the “Enter Old Code
Number” screen will appear, and you will need to
enter “1111”.
ENTER OLD CODE
NUMBER
Enter the old security code number to
access the screen that allows the code
change. If the wrong code is entered, the display will continue to ask
for the correct code and the security code cannot be changed.
ENTER NEW CODE
NUMBER XXXX
RE-ENTER NEW
NUMBER XXXX
NEW CODE NUMBER
ACCEPTED
Enter the new security code. Once the
new code is entered, the display will
automatically ask that the new code be
re-entered for verication. If the same new
code is re-entered, the display will conrm
that the new code has been accepted and
return to the Main Screen. If the new code
isre-enteredincorrectly,thedisplaywillreturntothe“EnterNew
CodeNumber”screenandtheprocesswillrepeat.
If you forget or misplace your security code, you can contact Wagner
customer service for assistance.
i
To inactivate the security function, enter “1111” at
the “Enter New Code Number” screen (this is the
default code that leaves the sprayer unlocked). As a
result, the Main Screen will appear at sprayer startup.
Prime Screen
PRIME
The Prime screen appears when the
pressurecontrolknobissetatthe“MIN”
setting.
Rapid Clean Screen
RAPID CLEAN
The Rapid Clean screen appears when the
pressure control knob is set at the RAPID
CLEANpositionandthePRIME/SPRAYvalveisinthePRIMEposition.
i
If there is no action at any menu screen for 30
seconds, the display will go back to the Main Screen.
5. Spraying technique
Injection hazard. Do not spray without the tip guard
in place. NEVER trigger the gun unless the tip is
completely turned to either the spray or the unclog
position. ALWAYS engage the gun trigger lock
before removing, replacing or cleaning tip.
The key to a good paint job is an even coating over the entire surface.
Keepyourarmmovingataconstantspeedandkeepthespraygunat
a constant distance from the surface. The best spraying distance is 25
to 30 cm between the spray tip and the surface.
25 - 30 cm
Keepthespraygunatrightanglestothesurface.Thismeansmoving
your entire arm back and forth rather than just exing your wrist.
Keepthespraygunperpendiculartothesurface,otherwiseoneend
of the pattern will be thicker than the other.
Trigger gun after starting the stroke. Release the trigger before
ending the stroke. The spray gun should be moving when the trigger
is pulled and released. Overlap each stroke by about 30%. This will
ensure an even coating.
25 - 30 cm25 - 30 cm
i
If very sharp edges result or if there are streaks in the
spray jet – increase the operating pressure or dilute
the coating material.
 previous next