Filter
Top Products
English
6
1. Assembly
Start
1. Insert the ends of the hose
bracket into the holes of the
handle as shown.
2. Remove the plug from inside
the hose ttings and remove the
cap on the outlet valve. Discard
both.
6. Remove cap from the Sureo
valve (a).
Thread the suction tube onto the
inlet valve and tighten rmly by
hand.
Note: Be sure that the threads are
straight so that the tting turns freely.
5. Thread the other end of the
hose to the spray gun. Hold
the gun with one adjustable
wrench, and tighten the hose
nut with the other.
4. Hold the port with an
adjustable wrench, and
tighten the hose with the
other.
7. Press the return tube onto
the return tube tting.
Squeeze clip over the return
tube tting to secure the
return tube.
3. Thread one end of the high
pressure spray hose to the
spray hose port.
You will need:
• Two adjustable wrenches
IMPORTANT: Do not plug in the
power cord until assembly is
complete.
Note: It will be much easier to attach the
hose to the sprayer if you uncoil it first.
1 2 3
654 7
(a)