Filter
Top Products
English
8
2. Load
Material
Start
You will need:
• The material you plan to spray
• Flat blade screwdriver
(cart models only)
• Light household oil /
Piston Oil™
• Extension
cord
• Waste bucket
1. Remove AutoOiler cap with a
at blade screwdriver.
Squirt Separating Oil into the
AutoOiler. Replace cap.
2. Push AutoOiler button 2-5 times
to lubricate the uid section.
Press button 2-3 times before
every use. Be sure to check
reservoir level (a) and rell as
necessary.
6. Turn the pressure control dial
to maximum pressure (+).
Turn the PRIME/SPRAY
knob to PRIME.
5. Place a full container
of spraying material
underneath the suction
tube (a).
Hold the return tube into a
waste container (b).
4. Fully depress the
Sureo valve to make
sure the inlet ball is
free.
7. Plug in the sprayer and
move the ON/OFF switch
to the ON (l) position.
Allow pump to run until
you see spray material
tube.
8. Switch the pump OFF (O).
Place return tube back into
material container and clip
return tube and suction tube
together.
3. Squirt a teaspoon of Piston
Oil™ (P/N 0516913, sold
separately) into the indicated
area.
Light household oil can be
substituted if necessary.
CART MODELS ONLY STAND MODEL ONLY
ALL MODELS
(a)
1 2 3
654
l
O
7
8
(a)
(b)
ON
SPRAY
PRIME