Filter
Top Products
You will need:
• Waste bucket
• Scrap material / cardboard
• Drop cloths to protect oors and
furnishings from overspray
Note: Motor will cycle ON and OFF while
spraying to regulate pressure. This is normal.
English
9
3. Getting
Material to
Flow
Start
Note: Motor will cycle ON and OFF while
spraying to regulate pressure. This is normal.
1. Point the spray gun into a
separate waste container.
Unlock the spray gun trigger.
Squeeze and hold trigger
for steps 2-3.
3. Continue to squeeze
trigger until the material
is owing freely through
the spray gun.
4. Peform the Pressure
Relief Procedure,
page 7.
2. Turn the power ON.
Turn the PRIME/SPRAY
knob to SPRAY.
5. Thread the spray tip guard
assembly onto the gun.
Tighten by hand.
6. Rotate spray tip forward to one of the
SPRAY positions.
Unlock the spray gun trigger.
7. Turn the power ON.
Turn the PRIME/SPRAY
knob to SPRAY.
8. Point the spray gun at a piece of
scrap material/cardboard.
Pull the trigger and practice spraying
(see pages 10-11).
1 3 42
l
O
SPRAY
PRIME
SPRAY
PRIME
ON
5 6 7 8
SPRAY
OR
l
O
SPRAY
PRIME
ON