Filter
Top Products
7
Using the DC Cable-Plug
Due to limitations in the common 12-volt outlet in a vehicle or boat, the Jazz 300
should only be used to supply AC power to products that require 150 watts (about
1.3 amps) or less. If your application requires more than 150 watts (but less than 240
watts continuous) or has a high start-up surge, see Using the DC Cable-Clips.
1. Attach the ring type connector marked with red to the positive (+) DC terminal
on the Jazz 300 and attach the ring connector marked with black to the negative (-)
DC terminal.
CAUTION! A reverse polarity connection (positive to negative) may
damage the Jazz 300. Damage caused by a reverse polarity connection is
not covered under warranty.
2. Tighten the nut on each DC terminal by hand until it is snug. Do not over tighten.
3. Insert the plug of this cable into the 12-volt outlet and switch the unit ON. See
Section 4 if the Jazz 300 does not operate properly after being connected.
4. When the Jazz 300 is not in use, unplug it from the 12-volt outlet to prevent slight
discharge of the battery.