xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
728
76-4 reconfig
Description
This command is used to re-Telnet to a member.
Format
reconfig [member_id <value 1-32> | exit]
Parameters
- Specify the serial number of a member.
- Specify the serial number of a member. The value is between 1 and 32.
exit - Specify to terminate command switch access.
Restrictions
Only Administrator-level users can issue this command.
Example
To re-Telnet to a member:
DGS-3420-28SC:admin#reconfig member_id 1
Command: reconfig member_id 1
DGS-3420-28SC:admin#
76-5 config sim_group
Description
This command is used to configure group information on the switch.
Format
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
Parameters
- Specify to add a specific candidate to the group.
<candidate_id 1-100> - Specify to add a specific candidate to the group.
<password> - (Optional) Specify the password of a candidate, if necessary.
delete - Specify to remove a specific member from the group.
<member_id 1-32> - Specify to remove a specific member from the group. The ID is from 1 to
