A SERVICE OF

logo

10 MS6000-EU-EN V1.4 8/12
3.5 Observing a waveform
Press the AUTO button and a 1 KHz square wave of approx. 5V peak-to-peak will appear in the display.
Press the CH1 button and remove Channel 1. Move the Probe to the CH2 BNC, push the CH2 button
and repeat these steps to observe the test signal on Channel 2.
3.6 Probe Examination
3.7 Safety
When using the probe, keep fingers behind the guard on the probe body to avoid electric shock. Do not
touch metallic portions of the probe head while it is connected to a voltage source. Connect the probe to
the oscilloscope and connect the ground terminal to ground before starting any measurements.