Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Parameter Tables
203
– Broadcast Filtering Table - Control the type of broadcast packets forwarded to the wireless network
– TCP/UDP Port Filtering - Filter IP packets based on TCP/UDP port
• Alarms Parameters
– SNMP Table Host Table Parameters - Enter the list of IP addresses that will receive alarms from the AP
– Syslog Parameters - Configure the AP to send Syslog information to network servers
• Bridge Parameters
– Spanning Tree Parameters - Used to help prevent network loops
– Storm Threshold Parameters - Set threshold for number of broadcast packets
– Intra BSS Subscriber Blocking - Enable or disable peer to peer traffic on the same AP
– Packet Forwarding Parameters - Redirect traffic from wireless clients to a specified MAC address
• RADIUS Parameters
– Set RADIUS Parameters - Configure RADIUS Servers and assign them to VLANs.
• Security Parameters - Access Point security settings
– MAC Access Control Parameters - Control wireless access based on MAC address
– Rogue Scan Configuration Table - Enable and configure Rogue Scan to detect Rogue APs and clients.
– 802.1x Parameters - Configure 802.1X Supplicant Timeout parameter
– Hardware Configuration Reset - Disable or enable hardware configuration reset and configure a configuration
reset password.
– Other Parameters - Configure Security Profiles that define allowed security modes (wireless clients), and
encryption and authentication mechanisms.
• VLAN/SSID Parameters - Enable the configuration of multiple subnetworks based on VLAN ID and SSID.
• Other Parameters
– IAPP Parameters - Enable or disable the Inter-Access Point Protocol
– Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters - Enable and configure Wireless
Multimedia Enhancement/Quality of Service parameters, QoS policies, mapping priorities, and EDCA parameters.
Apply a configured QoS policy to a particular SSID.
