Advanced Configuration AP-4000/4000M/4900M User Guide
Interfaces
67
Mesh
Mesh functionality can be enabled on only one of the AP’s wireless interfaces. When configured for Mesh, the AP’s
wireless interface simultaneously functions as a Mesh link and as a radio to service clients.
CAUTION: Mesh mis-configuration may cause problems in your wireless network. Before configuring an interface for
Mesh functionality, see Mesh Network Configuration.
NOTE: AP-4000 units must use software version 3.4 (or later) to enable mesh functionality. For information on upgrading
your unit’s software, see Installing the Software.
Basic Mesh Parameters
Figure 4-18 Basic Mesh Parameters
Configure the following basic parameters for Mesh functionality, and click OK.
NOTE: Changes to these parameters require a reboot in order to take effect.
• Mesh Mode: Use this drop down menu to enable/disable Mesh functionality on a wireless interface. When Mesh
Mode is set to Disable, all other parameters on this tab will be grayed out. To enable Mesh functionality, choose one of
the following:
– Mesh Portal: Choose this option if the AP will be connected directly to the wired backbone.
– Mesh AP: Choose this option if the AP will connect to the portal and backbone wirelessly.
NOTE: Proxim recommends enabling Auto Channel Select when configuring an AP as a Mesh AP. Auto Channel
Select is configured on the Wireless A or Wireless B page. See Wireless-A (802.11a/4.9 GHz Radio) and
Wireless-B (802.11b/g Radio) for more information.
