Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Parameter Tables
233
Encryption Key Format
If WEP security mode is configured, then the appropriate key size must be configured. The AP supports 63-, 128-, and
152-bit encryption keys. Encryption keys may be configured using either hexadecimal or ASCII values, as described in
the following table.
Each ASCII character corresponds to two hexadecimal digits. See ASCII Character Chart for ASCII/Hexadecimal
correspondence.
VLAN/SSID Parameters
Other Parameters
IAPP Parameters
NOTE: These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
Key Length Hexadecimal ASCII
64-bit 10 characters (0 - F) 5 alphanumeric characters
128-bit 26 characters (0 - F) 13 alphanumeric characters
152-bit 32 characters (0 - F) 16 alphanumeric characters
Name Type Value Access CLI Parameter
VLAN Group N/A R vlan
Status Integer enable
disable (default)
RW vlanstatus
Management ID VlanId -1 (untagged)
or 1 - 4094
RW vlanmgmtid
Name Type Value Access CLI Parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable
RW iappstatus
Periodic Announce
Interval (seconds)
Integer 80
120 (default)
160
200
RW iappannint
Announce Response
Time
Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW iapphandtout
Max. Handover
Retransmissions
Integer 1 - 4 (default 4) RW iapphandretx
Send Announce Request
on Startup
Integer enable (default)
disable
RW iappannreqstart
