169Starting a Multipoint Videoconference
Chapter 8: Multipoint Videoconference
2 Press the button on the Remote Commander, or press the PUSH
ENTER button to open the submenu, press the V or v button to select “
On”, then press the PUSH ENTER button.
The (multipoint) mark is added to the upper left of the selected name in the
Phone Book list and the remote party is specified to the party for multipoint
connection.
You can add the marks for up to five parties using the same procedure as
above. The marks added are displayed at the upper right corner of the
Phone Book menu.
To delete the mark from the name list, press the button again, or press the PUSH
ENTER button to open the submenu, press the V or v button to select “ Off”, then
press the PUSH ENTER button.
3 Select one of the remote parties with the mark.
4 Press the CONNECT/DISCONNECT ( / ) button on the Remote
Commander, or press the PUSH ENTER button to open the submenu, press
the V or v button to select “ Dial”, then press the PUSH ENTER button.
Note
Phone Book
Recent
0-9
A-I
J-S
T- Z
RECENT
IP
TOKYO Bob John
IP
OSAKA
ISDN
NEW YORK
ISDN
PARI S
Edit
Copy
Dial
Delete
On
PAR IS
1234567
Phone Book
New Entry
Recent
0-9
A-I
J-S
T- Z
RECENT
IP
TOKYO Bob John
IP
OSAKA
ISDN
NEW YORK
BOSS
0123456
ISDN
PARI S
Number of specified points
Multipoint mark
