60 Registering Local Information
The Status menu shows the current status of
communication.
The ISDN Line Status, LAN Line Status or
LAN Connection Status will also be
displayed depending on the line interface
used.
Communication Status
One page for each point connected to the
system will be displayed. The connected
point is shown at the upper right corner of
the page as “Connection A (or B, C….)”.
The terminal’s name of the point is also
displayed at its side.
The items below are shown both in the
columns for “Encode” and “Decode”. The
descriptions under “Encode” show the
setting status on the local system and those
under “Decode” show the status on
receiving.
Audio Mode
Shows the current audio compression
format.
Video Mode
Shows the current video compression
format.
The audio compression and video compression
formats used for communication with a remote
party may differ from the settings in this menu,
depending on the status of videoconferencing
system on the remote site.
Frame Rate
Shows the maximum frame rate of motion
pictures.
Rate
Displays the number of lines connected and
a transmission rate during communication.
MLP Rate
Shows the MLP (Multi Layer Protocol) rate.
HMLP Rate
Shows the HMLP (High Speed Multi Layer
Protocol) rate.
LSD Rate
Shows the LSD (Low Speed Data) rate.
Line I/F
Displays the line interface you are using.
Camera Control
Shows whether control of each other’s
camera is enabled or not.
Data Control
Shows whether the T.120 data conference is
enabled or not.
DSB
Shows whether the PCS-DSB1 Data
Solution Box is connected or not.
Whiteboard
Shows whether the mimio Xi attached to
your whiteboard is enabled or not.
ISDN Line Status
Status Menu
Note
Status
Communication Status
Cancel
Connection A
Audio Mode
Video Mode
Frame Rate
Rate
MLP Rate
HMLP Rate
G.728
(Encode) (Decode)
H.261CIF
15fps
G.728
H.261CIF
15fps
2 x 64k2 x 64k
OFF
OFF
OFF
OFF
Line I/F
Camera Control
Data Control
DSB
Whiteboard
BRI
ON
ON
ON
OFF
LSD Rate
6400 6400
Page: 1/4
Page:
2/4
ISDN Line Status
Status:
: No call in progress
Cause Code:
A
1
End
Status
: Call in progress
: No network
: Connected
: Call failed
A
2
B
1
B
2
C
1
C
2 D1
D
2
E
1
E
2
F
1
F
2
