Filter
Top Products
E - IEC Mode Command Summary
178
SENSe:CURRent:PREFerence
This command sets the phase reference for current harmonic phase measurements. If VOLTage is
selected, the reference is the fundamental component of the measured output voltage. If CURRent is
selected, the reference is the fundamental component of the measured output current.
Command Syntax
SENSe:CURRent:PREFerence <CRD>
Parameters
VOLTage | CURRent
*RST Value
CURRent
Examples
SENS:CURR:PREF CURR
Query Syntax
SENSe:CURRent:PREF?
Returned Parameters
<CRD>
Related Commands
ABORt MEAS:ARR:CURR:PHAS
SENSe:WINDow
This command sets the window function which is used in harmonic measurements. The choice of
parameters is affected by the SYSTem:CONF command. If NORMal is selected, HANNing, KBESsel, or
RECTangular may be selected. IF IEC mode is selected, only HANNing and RECTangular may be
selected. KBESsel is the preferred window and should be used for most measurements in NORMal
mode. HANNing and RECTangular are available for making harmonic current measurements that comply
with the regulatory requirements.
Command Syntax
SENSe:WINDow [:TYPE] <window>
Parameters
HANNing | KBESsel | RECTangular
*RST Value
KBESsel
(RECTangular is the default setting when the Agilent 14761A software is
run)
Examples
SENS:WIND RECT
Query Syntax
SENSe:WINDow?
Returned Parameters
<CRD>
Related Commands
MEASure:ARRay:CURRent:HARMonic? SYSTem:CONF
MEASure:CURRent:HARMonic?
MEASure:ARRay:VOLTage:HARMonic?
MEASure:VOLTage:HARMonic?