Agilent Technologies 6843A Welding System User Manual


 
Language Dictionary - 3
77
LIST:VOLTage
Phase Selectable
This command specifies the output voltage points in a list. The voltage points are given in the command
parameters, which are separated by commas. The order in which the points are entered determines the
sequence in which they are output when a list is triggered. Changing list data while a subsystem is in list
mode generates an implied ABORt.
The maximum peak voltage that the ac source can output is 425 V peak. This includes any combination of
voltage, voltage offset, and function shape values. Therefore, the maximum value that can be
programmed depends on the peak-to-rms ratio of the selected waveform. For a sinewave, the maximum
voltage that can be programmed is 300 V rms.
NOTE: For Agilent models 6814B, 6834B and 6843A, you cannot program a voltage that
produces a higher volt-second on the output than a 300 Vrms sinewave.
Command Syntax
[SOURce:]LIST:VOLTage[:LEVel] <NRf+> {,<NRf+>}
Parameters
For sinewaves: 0 to 300 | MAXimum | MINimum
Unit
V
(rms voltage)
Examples
LIST:VOLT 115,126,120 LIST:VOLT MAX,120,MIN
Query Syntax
[SOURce:]LIST:VOLTage[:LEVel]?
Returned Parameters
<NR3> {,<NR3>}
Related Commands
LIST:VOLT:POIN? LIST:COUN LIST:DWEL LIST:STEP
LIST:VOLT:SLEW LIST:VOLT:OFFS
LIST:VOLTage:POINts?
This query returns the number of points specified in LIST:VOLTage. Note that it returns only the total
number of points, not the point values.
Query Syntax
[SOURce:]LIST:VOLTage[:LEVel]:POINTs?
Returned Parameters
<NR1>
Examples
LIST:VOLT:POIN?
Related Commands
LIST:VOLT
LIST:VOLTage:SLEW
Phase Selectable
This command specifies the output voltage slew list points. The slew points are given in the command
parameters, which are separated by commas. The order in which the points are entered determines the
sequence in which they are output when a list is triggered. Changing list data while a subsystem is in list
mode generates an implied ABORt.
Command Syntax
[SOURce:]LIST:VOLTage:SLEW <NRf+> | INF {,<NRf+> | INF}
Parameters
0 to 9.9E37 | MAXimum | MINimum | INFinity
Unit
V
(volts per second)
Examples
LIST:VOLT:SLEW 10,20,1E2
Query Syntax
[SOURce:]LIST:VOLTage:SLEW?
Returned Parameters
<NR3> {,<NR3>}
Related Commands
LIST:VOLT:SLEW:POIN? LIST:COUN LIST:DWEL LIST:STEP