Filter
Top Products
3 - Language Dictionary
90
VOLTage:OFFSet:SLEW:TRIGgered
Agilent 6811B, 6812B, 6813B, Only
This command selects the dc offset slew rate that will be set during a triggered step or pulse transient. A
parameter of MAXimum or INFinity sets the slew to its maximum possible rate. The SCPI representation
for infinity is 9.9E37.
Command Syntax
[SOURce:]VOLTage:OFFSet:SLEW:TRIGgered <NRf+> | INFinity
Parameters
0 to 9.9E37 | MAXimum | MINimum | INFinity
Unit
V
(volts per second)
*RST Value
INFinity
Examples
VOLT:OFFS:SLEW:TRIG 50 VOLT:OFFS:SLEW:TRIG MAX
Query Syntax
[SOURce:]VOLTage:OFFSet:SLEW:TRIGgered?
Returned Parameters
<NR3>
Related Commands
VOLT:OFFS:SLEW VOLT:OFFS:SLEW:MODE
VOLTage:PROTection
Phase Selectable
This command sets the overvoltage protection (OVP) level of the ac source. If the peak output voltage
exceeds the OVP level, then the output is disabled and the Questionable Condition status register OV bit
is set (see Chapter 4 under Programming the Status Registers). An overvoltage condition can be cleared
with the OUTPut:PROTection:CLEar command after the condition that caused the OVP trip is removed.
The OVP always trips with zero delay and is unaffected by the OUTPut:PROTection:DELay command.
Command Syntax
[SOURce:]VOLTage:PROTection[:LEVel] <NRf+>
Parameters
0 to 500 | MAXimum | MINimum
Unit
V
(peak voltage)
*RST Value
MAXimum
Examples
VOLT:PROT 400 VOLT:PROT:LEV MAX
Query Syntax
[SOURce:]VOLTage:PROTection[:LEVel]?
Returned Parameters
<NR3>
Related Commands
OUTP:PROT:CLE OUTP:PROT:DEL
VOLTage:PROTection:STATe
Agilent 6811B, 6812B, 6813B, Only
This command enables or disables the over-voltage protection feature.
Command Syntax
[SOURce:]VOLTage:PROTection:STATe <Bool>
Parameters
0 | 1 | OFF | ON
*RST Value
OFF
Examples
VOLT:PROT:STAT 1 VOLT:PROT:STAT ON
Query Syntax
[SOURce:]VOLTage:PROTection:STATe?
Returned Parameters
<NR3>
Related Commands
VOLT:PROT