Filter
Top Products
Operating and Safety Instructions
13
5. INSTALLATION OF THE MACHINE
The machine should be located at least 40 cm in front of the back wall. The machine is
equipped with a burr collection bag connector and power supply socket on the back
side.
5.1. PREPARATION
5.1.1.
The outer dimensions of the machine are stipulated in the Dimensions page (Page
6). The ground, where the machine will be placed, should be even, solid enough to bear
the weight of the machine.
5.1.2.
At the miter saws PEGASUS - SKAT all parts are delivered by the manufacturer ready
for use.
5.1.3.
If you have purchased a conveyor, which is offered an option, connect to either
side of the machine as shown in Illustration 1.
5.1.4.
Before starting the machine, remove the transport safety part as shown in Illustration
2.
Illustration-1
Illustration-2
Head Fixing
Plate