Filter
Top Products
Operating and Safety Instructions
19
Figure-4
Always ensure that the clamps are positioned outside of the operation area of the saw
blade.
8. SAFE INSTALLATION OF THE SAW BLADE
8.1
To remove the circular saw blade from the blade shaft, follow the instructions below.
8.1.1.
Remove the M8 screw (Figure 4, No. 55) by turning it counter clockwise with a 8 mm
hexagonal key. (Hold the saw blade shaft at the opposite end with a 17 mm wrench key
and prevent so that the shaft turns.
8.1.2.
Remove the washer No. 54 and the outer nut washer No. 47.
8.1.3.
Take out the saw blade carefully.
8.1.4.
Insert the new saw blade on the saw blade shaft, ensuring correct rotation direction.
8.1.5.
Insert the other parts (washer, outer nut washer) in reverse order as removal.
8.1.6.
Tighten the M8 screw while holding the blade shaft with a 17 mm wrench key in fix
position. It is necessary to sharpen / replace the saw blade in certain intervals depending
on the cutting material.
8.1.7.
If the cut material leaves burr after the cutting operation or if the saw blade is
strained, it needs to be sharpened / replaced.
CAUTION !
WRONG
CORRECT