Filter
Top Products
-21-
USE IN ROUTER TABLE
Your router can also be used in a router table.
The RA1161 fixed base is designed to allow
easy depth adjustment in a table. The RA1162
"D" D-Handle base will not fit in most router
tables.
The RA1166 Plunge Base is
not recommended for use
in a router table. Damage to plunge router
base may occur.
To eliminate the hassle of installing your
router’s own base on the router table and later
having to convert it back for non-table use,
Bosch offers the optional RA1165 Undertable
Router Base (Fig. 28). The RA1165 base is
designed to be permanently attached your
router table, leaving your other router bases
ready for non-table use. The motor can be
quickly moved from base to base — without
any tools!
!
CAUTION
Shown after
subbase has
been removed
Hole for Hex
Wrench
Quick-release
clamp lever
and depth
adjustment
controls should
face the front of the router table
Mounting
Plate
10-24 Screw
FIG. 28
Hex
Wrench
4. Prepare the Centering Device:
• Use narrow end of steel shaft when
inserting into 1/4” collet, wider end of cone
when inserting into 1/2” collet.
• When centering subbase or templet guide
that has opening of more than ½”, slide
the wide plastic sleeve over the steel
shaft.
5. Slide centering sleeve through the sub-base
or templet guide and into collet. Tighten
collet nut with fingers to put slight grip on
centering cone.
6. Lightly press centering sleeve into sub-base
or templet guide to center.
7. Tighten the pan-head screws. Remove
centering sleeve.
8. The precision centering of the sub-base or
templet guide is complete.
CENTERING CONE – Used when centering
the subbase itself or wide templet guides.
Bosch Bushing External Internal Max
Templet Depth Diameter Diameter Bit/Cutter
Guide Diameter
ABB
RA1101 3/16” 5/16” 1/4” 3/16”
RA1103 9/64” 5/16” 17/64” 13/64”
RA1105 9/64” 7/16” 3/8” 5/16”
RA1107 5/16” 7/16” 3/8” 5/16”
RA1109 7/16” 1/2” 13/32” 11/32”
RA1111 3/16” 5/8” 17/32” 15/32”
RA1113 1/2” 5/8” 17/32” 15/32”
RA1115 3/16” 3/4” 21/32” 19/32”
RA1117 31/64” 13/16” 5/8” 9/16”
RA1119 31/64” 1” 25/32” 21/32”
RA1121 7/16” 1-3/8” 1-19/64” 1-15/64”
MAXIMUM BIT/CUTTER SIZE FOR
TEMPLET GUIDES
When using a templet guide, use only router
bit with cutters that are 1/16” less than the
internal diameter of the templet guide, such as
in the table below.
USE WITH THREADED
TEMPLET GUIDES
Also available as an optional accessory is an
additional adapter, the RA1100, that allows
use of conventional threaded templet guides
with the Bosch quick-release system.
BM 2610018532 01-12:BM 2610018532 01-12.qxp 1/23/12 9:21 AM Page 21