Filter
Top Products
-19-
Read instruction manual first! Remove battery pack and nails from the tool
before making adjustments, assembling accessories or servicing.
%0,!#).'%452.934%-
!
WARNING
/2%0,!#%25""%2#/2$3&/,,/734%03"%,/7
1. Remove metal cap. Using 3mm allen wrench,
remove 3 screws and set aside (Fig. 15).
2. Remove drive block pin #1 by pushing on
one side. Pull on other end to remove. *TIP*
16ga finish nail can be used to slide pin out
(Fig. 16).
3. Locate pin #2. To remove, use pin #1 and
push pin #2 from either side until enough of
the pin has been exposed. Remove
completely. Place both pins in secure place
for reassembly (Fig. 17).
4. Sub Assembly. Holding tool securely with
one hand, use other hand to remove driver
sub-assembly by grabbing both sides and
then pull directly back (Fig. 18).
5. The Driver Sub Assembly consists of 5 parts
(Fig. 19):
A) Driver Block Assembly (1)
B) Guide Rails (2)
C) Guide Sleeves (2)
D) Return Frame (1)
E) Rubber Cords (2)
6. Remove worn or damaged rubber cords.
Align new rubber cords with tabs on the back
of the return frame first (Fig. 20).
FIG. 18
FIG. 16
FIG. 17
FIG. 15
FIG. 19
FIG. 20
PIN #1
B
C
B
A
C
D
E
PIN #2
PIN #1
BM 2610034445 03-14_FNH180 3/27/14 11:52 AM Page 19